command to find mac address of cisco router

Different Types of Router Memory: FLASH, NVRAM, DRAM, ROM.Resolved IPv4 address to MAC address mappings.ĭisplays status of configured Layer 3 protocolsĭisplays configuration currently running in RAMĭisplays the IPv4 routing table of the router “SnabaynetworkingR1” If the cable is DCE, DTE, or not attachedĭisplays the system clock of the router “SnabaynetworkingR1”.ĭisplays the configured hostnames and theirĬorresponding IP addresses of the router “SnabaynetworkingR1”ĭisplays all users connected to the routerĭisplays history of Cisco IOS commands usedĭisplays info about loaded Cisco IOS softwareĭisplays the ARP table of the router “SnabaynetworkingR1”.ĪRP table is the table which contains the

Statistics display if the clock rate is set and SnabaynetworkingR1#show controllers serial 1/0ĭisplays statistics for interface hardware serial 1/0. Status and IPv6 address assigned in router “SnabaynetworkingR1” SnabaynetworkingR1#show ipv6 interface briefĭisplays a summary of all IPv6 interfaces, including Status and IPv4 address assigned in router “SnabaynetworkingR1” SnabaynetworkingR1#show ip interface briefĭisplays a summary of all IPv4 interfaces, including All these commands retrieve information in the Cisco switch and router. To know All Show Commands in Cisco Switch and Router keep reading this article till the end. One of the most powerful command in IOS is Show. Cisco router runs on an operating system called the IOS (Internetwork Operating System).To enable the administrator to retrieve information and change the device’s settings.

Command to find mac address of cisco router